Skip to content

Richard Body

← User Feedback Forum for Innovyze Products and Services

My feedback

44 results found

  1. Allow pollutographs to apply on subcatchments

    5 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    RECEIVED  ·  0 comments  ·  Storm Sewer & Flood Modeling » Hydrology  ·  Admin →
    Richard Body shared this idea  · 

  2. Rating curves / equations as downstream boundaries

    9 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    RECEIVED  ·  0 comments  ·  Storm Sewer & Flood Modeling » River Modeling  ·  Admin →
    Richard Body shared this idea  · 

  3. Simulation engine control update

    15 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    4 comments  ·  Storm Sewer & Flood Modeling » Hydraulics  ·  Admin →
    IN DISCUSSION  ·  pascal.lang responded

    Thank you for the addition of this request, we are in discussions about how this might be achieved as the level of awareness of tasks is varied between agents. Would a dashboard showing who sent which simulation where (which are still ongoing) be sufficient? This would be without the progress those simulations have already made available as a first step.

    Richard Body supported this idea  · 

  4. Adjust mesh locally without remeshing all

    26 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    0 comments  ·  Storm Sewer & Flood Modeling » 2D Flooding  ·  Admin →
    ON ROADMAP  ·  pascal.lang responded

    We are looking into this, but for the majority of cases it might be that there is already a significant improvement related to this with the new “Clip meshing” which was released with version 11.0 of the software, but in a prototype state, please ensure outputs are reviewed before use. The reason it provides an improvement is that it does a coarse mesh first (which is likely to remain unchanged if only small amendments are made) and follows this with a more detailed mesh after. It would be great to get any feedback you might have on your experiences with the Clip meshing and consistency of results.

    Richard Body supported this idea  · 
1 3 Next →

Feedback and Knowledge Base

(thinking…)