Storm Sewer & Flood Modeling
Welcome to the Innovyze Stormwater, Sewer, and Flood modeling feedback page.
48 results found
-
Can ICM add particle tracking module?
When there are pollutants that enter a system from various sources then it would be good to have pollutant tracing functionality which shows the source and the pollutant moving through the system, giving an idea of the rate at which it travels and impacts areas downstream.
10 votes -
Modelling of mud and other non-Newtonian flows
We've a lot of work at the moment modelling the failure of tailings dams. Tailings dams typically have material that acts in a non-Newtonian manner. To effectively model these sorts of fluids would require the inclusion of additional fluid properties. The Bingham method (https://en.wikipedia.org/wiki/Bingham_plastic) has been successfully applied in other applications.
5 votes -
Infoworks ICM - XPSWMM
Provide a easy model/network transport option from one program to the other. Many municipalities within WA utilise XPSWMM and therefore are note able to read an ICM model.
2 votes -
Simple means to set initial storage area water surface elevations
Please incorporate a system for setting initial water surface elevations in storage nodes that works as easily as the process is in XPSWMM or HEC-RAS. The program should hold this water level during warm-up stabilization.
4 votes -
Add SWMM5 Ideal Pump to InfoWorks ICM
Does InfoWorks ICM have an equivalent to an ideal pump in SWMM which pumps whatever is entering the SPS out of the SPS?
It would be a good feature to include into infoworks as I needed to play around a bit to get it. I found I had to add line 2 or the pump kept on turning off rather than flow pacing.
I have seen a screw pump used previously to pump out what comes into the SPS but dependent upon the head discharge parameters this can back up the incoming sewer. If I set a curve similar to…
6 votes -
Update Storage array from ground model
Provide the ability to update a storage array (curve) from ground model without destroying manually entered data
7 votes -
Allow multiple subcatchments with the same RTK set to drain to one node.
allow subcatchments with different RTKs to drain to the same node (Very useful for future loads and different land uses).
1 vote -
Refine FHWA junction losses
There are some improvements that can be made to FHWA junction losses based on experimental results provided by Wood Rodgers.
2 votes