Storm Sewer & Flood Modeling
Welcome to the Innovyze Stormwater, Sewer, and Flood modeling feedback page.
48 results found
-
Can ICM add particle tracking module?
When there are pollutants that enter a system from various sources then it would be good to have pollutant tracing functionality which shows the source and the pollutant moving through the system, giving an idea of the rate at which it travels and impacts areas downstream.
10 votes -
Add SWMM5 Ideal Pump to InfoWorks ICM
Does InfoWorks ICM have an equivalent to an ideal pump in SWMM which pumps whatever is entering the SPS out of the SPS?
It would be a good feature to include into infoworks as I needed to play around a bit to get it. I found I had to add line 2 or the pump kept on turning off rather than flow pacing.
I have seen a screw pump used previously to pump out what comes into the SPS but dependent upon the head discharge parameters this can back up the incoming sewer. If I set a curve similar to…
6 votes -
Simulation engine control update
Since the beginning of ICM and allowing to send simulation to other computers in the network, there was a need for knowing exactly who is currently sending simulations and to which computer. Please update the ICM with this improved functionality for the normal user, not for admin only. These people are the ones who send simulation to the network, not IT people!
15 votesThank you for the addition of this request, we are in discussions about how this might be achieved as the level of awareness of tasks is varied between agents. Would a dashboard showing who sent which simulation where (which are still ongoing) be sufficient? This would be without the progress those simulations have already made available as a first step.
-
Allow multiple subcatchments with the same RTK set to drain to one node.
allow subcatchments with different RTKs to drain to the same node (Very useful for future loads and different land uses).
1 vote -
Refine FHWA junction losses
There are some improvements that can be made to FHWA junction losses based on experimental results provided by Wood Rodgers.
2 votes -
RDII Analyst (in ICM)
Provide RDII Analyst without needing to purchase InfoSWMM
24 votes -
Update Storage array from ground model
Provide the ability to update a storage array (curve) from ground model without destroying manually entered data
7 votes -
Conveyance on cross section lines
Provide cross section conveyance for each cross section
14 votes
