Gregory Smith
My feedback
13 results found
-
3 votes
-
12 votesGregory Smith
supported this idea
·
-
10 votesGregory Smith
supported this idea
·
-
7 votesGregory Smith
shared this idea
·
-
3 votesGregory Smith
supported this idea
·
-
21 votesGregory Smith
supported this idea
·
-
12 votesGregory Smith
supported this idea
·
-
5 votesGregory Smith
supported this idea
·
-
8 votesGregory Smith
supported this idea
·
An error occurred while saving the comment -
2 votesGregory Smith
shared this idea
·
-
8 votes
Interesting idea.
We need more information on the problem of pipe clashes. Are these unconnected pipes in the model or are they referencing Asset networks, or Water networks?
How granular of a view does one need? I.e. are you interesting in generally where these crossing occur, or are you trying to identify how close you can cross something else?
Gregory Smith
supported this idea
·
An error occurred while saving the comment Gregory Smith
commented
I see this as an excellent (and necessary) addition to ICM.
A typical example is where there is a constraint of (say) a foul sewer line that crosses a stormwater line that is the subject of the design. When adjusting pipe depths, the ability to "see" the sewer line in a long section will assist the design to ensure that there is sufficient minimum (and measurable) clearance between the 2 pipes. The same could be applied to any design or existing constraints that may affect a design.
The current work around is by duplicating scenarios in CAD.
I would like this feature to be a very simple exercise of being able to create a conduit (without nodes) with just an upstream & downstream invert. (and it may only be a metre long .... for example if it is pipe
(or even a cable) that has just been potholed by survey). -
7 votes
Currently under discussion how to support AutoCAD Civil 3D drawings files, including prioritization of objects and defining workflows.
Gregory Smith
supported this idea
·
An error occurred while saving the comment Gregory Smith
commented
Civil 3D files would be a great starting point.
-
14 votes
An error occurred while saving the comment Gregory Smith
commented
Regarding Save grid layout: I find that columns I don't need cannot be hidden as that option is greyed out (as is hide empty tabs). In fact, I'm struggling to find any columns I can hide, which then makes no point in trying save the grid layout (but most likely I'm doing something wrong).
I agree. It is a current failing of the labelling in ICM that the decimal places it determines, may or may not be relevant to reporting a particular model.
Greg Smith